Hi,
I've recently purchased a 991.1 C2S but I'd like to swap the front bumper for the aero kit / GTS one (gen 1). I've done some research and understand it is a straight swap and I can reuse the current headlamp washers, DRLs and side indicators.
However, the grills (air intakes) at each side look different and I have parking sensors on the stock bumper (the ones at each end are molded into the gray intakes). I was thinking if they didn't fit into the new gts bumper, I would get some sort of mesh and add that instead of the grey intakes (with the parking sensor bonded & clipped into the top corner).
Has anyone done anything similar or managed to reuse the plastic grill from a stock bumper with the GTS bumper (or bought an equivalent grill to retro fit)?
Many thanks in advance
I've recently purchased a 991.1 C2S but I'd like to swap the front bumper for the aero kit / GTS one (gen 1). I've done some research and understand it is a straight swap and I can reuse the current headlamp washers, DRLs and side indicators.
However, the grills (air intakes) at each side look different and I have parking sensors on the stock bumper (the ones at each end are molded into the gray intakes). I was thinking if they didn't fit into the new gts bumper, I would get some sort of mesh and add that instead of the grey intakes (with the parking sensor bonded & clipped into the top corner).
Has anyone done anything similar or managed to reuse the plastic grill from a stock bumper with the GTS bumper (or bought an equivalent grill to retro fit)?
Many thanks in advance